⚡ DPS Control

Disconnected

Device Baud Addr Poll ms Timeout ms Reconnect to last port without asking Device list: built-in Baud rate changes need a reconnect. Settings are locked while a tool is running.

Output —

--.--V

set -- V
in -- V

-.--A

set -- A

--.--W

R_load -- Ω

------

Output is

—

not connected

Esc = emergency output OFF and stop all tools

Setpoints

Voltage

Current

Auto-sync fields from supply

Backlight3

Enter in a field applies it. Step buttons apply immediately. An orange frame means the field holds a value the supply doesn't have yet.

Protection (M0)

OVP

OCP

OPP

Writes the active data group M0 (registers 0x52–0x54).

Live chart

Measurements & logging

0:00:00elapsed

0.0000Ah (output on)

0.0000Wh (output on)

--U min V

--U max V

--I max A

--P max W

--samples / s

--read round-trip ms

0 / 0frames ok / failed

Log 0 rows

Parameter Start End Step Dwell per step

Output ON at start Output OFF at end

Idle

Sweep result0 points

One point is captured at the end of each dwell: setpoint, measured U, I, P and mode.

Set	U V	I A	P W	Mode

#	Voltage V	Current A	Output	Duration s

Loops (0 = forever) Output OFF when finished

Idle

When armed, the output switches OFF as soon as any enabled condition is met. Typical use: CC/CV battery charging with a termination current.

Current falls below	A for s, checked after s
Voltage reaches	V
Current reaches	A
Power reaches	W
Time elapsed	min
Charge delivered	Ah
Energy delivered	Wh

Reset Ah/Wh counters when arming Beep on cutoff

DISARMEDarmed for 0:00:00

M0 = power-on/active group · M1, M2 = quick-recall groups · M3–M9 = storage

Group	U V	I A	OVP V	OCP A	OPP W	Backlight	Output at power-on

Read start count

Write reg value

Reg	Name	Hex	Dec

Frame log include polling follow

Output —

Setpoints

Protection (M0)

Live chart Elapsed hh:mm:ss.sSecondsTime of day 30 s1 min5 min15 min1 hAll PauseClear

Measurements & logging

Live chart